MuxLab HDMI over IP PoE Transmitter (Video Wall)
The Video Wall over IP Extender Kit with PoE allows HDMI equipment to create a Video Wall of user configurable size (X by Y) supporting 100 s of screens, depending on network bandwidth, utilizing one receiver for each display in the array. The transmitter unit can be connected using a LAN switch (PoE or non-PoE), with maximum distances of 330ft (100m) of Cat 5e/6 cable between equipment.
The MuxLab Pro Digital Network Controller (500811) is available to simplify configuration and control and allows for third party smartphone and tablet management.
The transmitter (500754-TX) and receiver (500754-RX) also support PoE (PD) if used with a PoE (PSE) Ethernet switch. The kit comes with one (1) transmitter and one (1) receiver. The IR Emitter and IR Sensor, if required, may be purchased separately for IR based remote control applications.
For the point-to-multipoint and multipoint-to-multipoint configuration the Ethernet switch must have Gigabit ports, DHCP server capability and IGMP communications protocol. MuxLab recommends using the Cisco SG300 Series Managed Switches.
Key Features
- Configure a Video Wall array with 100 s of displays, depending on network bandwidth
- HDMI 1.3
- Supports up to 1080p resolutions
- Visually lossless video (1 frame latency)
- Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
- Transmission up to 330ft (100m) over Cat5e/6
- Transmission up to 390ft (120m) between one (1) TX and one (1) RX when no LAN switch is used in a point-to-point scenario
- Supports RS232 and IR transmission for remote control
- PoE powered
- Control via any web device (mobile, tablet) with use of model 500811 (Pro Digital Network Controller)
