Skip to main content
GE-G-48VMONK1

GEN ENERGY GE-G-48VMONK1 ePriceSource

GEN ENERGY

$2,557.00
Write a Review
SKU:
GE-G-48VMONK1
Availability:
In Stock* Usually Ships Next Day - Ask Questions: sales@epricesource.com
Shipping:
$18.88 (Fixed Shipping Cost)
Adding to cart… The item has been added

GEN ENERGY 48V LED Light On-Location Mobile Power Solution Kit (V-Mount, Drawing 650W)

How to use

  • G-PB48 can power max. 500W with G-B100/290W 22A or G-B100/390W 26A
  • G-PB48 M2 can power max. 500W with G-B100/290W 22A max. 650W with G-B100/390W 26A
  • Use only GEN ENERGY's 22A or 26A batteries.
  • Use only 3-pin XLR with thick cable over 16AWG

GEN ENERGY 14.4V, 390Wh / 27.2Ah Li-Ion V-Mount Battery (26A Max. Discharge Rate)

  • This battery has 26A Min.312W, the biggest power in the world, which was born for ALEXA LF and Skypanel S60 full power working solution and other high power lightings.
  • You can use only 1 pc of 14.4V battery for ALEXA LF and 2 pcs of batteries for Skypanel S60 and other high power lightings.
  • G-P22ALF plate is needed for ALEXA LF with this 1 pc of battery.
  • G-PB48 power distributor is needed for Skypanel S60 with 2pcs of it.
  • Shock-proof, Short-proof, Lowest impedance.

CHARGE

  • Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
  • Charge the battery to full before first use.
  • When you charge this battery, Battery capacity LED gauge button will turn on indicating the capacity being charged.
  • Lithium ion batteries have a slight self discharge, therefore it is recommended to charge prior to use.

DISCHARGE

  • Do not use the battery (Main, D-Tap, USB) while charging. If so, it may cause a charging error or damage the charger.
  • Camera's low voltage alarm is recommended to set 13V.
  • Battery will stop at 12V to extend its life.
  • * Microwave transmitters with 5W outputs or over should be kept as far away from the battery. It may disrupt or stop supplying power.
  • Be sure to remove the battery from the device after use. If so, it will consume large standby power and over-discharge protection may be activated.
  • USB is activated by pushing Battery capacity LED gauge button. USB power will turn on automatically 30 minute after no use.
  • Battery run time reduces when it is working below or above the recommended temperature range.
Full Mfg Warranty
!